To facilitate the users more easily when installing the regulator, where Deng Pan, will share under regulator installation and simple, hope to be helpful. 

 1, the voltage regulator on the power distribution board, the choice of instrument power fuse, so as to guarantee the security of electricity. 

 2, electrical equipment, power supply access to the output plane, pay attention to the value of consistent electrical nominal input value and the regulator can not go wrong. 

 Installed, the first to open the power supply switch, if the work is light, then we observe under the voltmeter indicates whether the value of normal. When the output voltage is normal, and then turn electrical equipment power switch, the voltage regulator that is able to automatically adjust the voltage, the normal power supply. 

 When unused for long periods of electrical equipment, be sure to turn off the switch of the electrical equipment to avoid the electricity loss. 

 5, the regulator must not set out to use. The mains voltage is low, the output capacity to reduce the load the regulator should be reduced accordingly. 

 Elected appliances refrigerators, air conditioners, water pumps and other equipment with the motor running, should be selected more than 3 times the capacity of the regulator, to prevent the device from starting current exceeds the regulator fuse current or over-current protection circuit breaker current so that the regulator The device blown fuse or circuit breaker tripping or voltage drop is too large and unable to work. 

 7, and regulator equipment in contact with the surface to ensure adequate planting surface to avoid run-time fever. 

 8, no matter what type of regulator, then all the input-output line, the need to close the switch again to open, check to ensure that the normal output voltage in order to re-open. 

 Regulator (http://www.pandeng.org.cn)